Key words: iron remover, magnetic separator, the eddy current separator, weighing feeder, batching scales, electronic belt scale
Magnetic separator magnetic declination need not regular adjustment, which can keep the good state, so as to make the equipment efficiency is more stable, normal play.So how to adjust the equipment mdec correctly?Take a look at below steps in detail.
(1) magnetic separator roll Jane on both ends of the shaft seat first nut loose a few buttons (not unscrew, loose is a few buttons, a total of four screws), is a fixed shaft end shaft nut, its purpose is to make the shaft is in a state of adjustable (magnetic separator magnetic part is fixed on the large shaft).
(2) concentrate on the magnetic separator into the material side discharging scraper to remove (need to two people hold two wrench, taking it from both ends, scraper is heavier, please be careful, don't hit to the drum, more don't hit people).
(3) in a small nails or the end of the electrode, don't be too long, to 2 cm is preferred.
(4) from the magnetic separator into the material side, with a small nail (or the end of the electrode) from the upper part of the drum slowly downward slide, slide to a lower position, central hand nail produces pulling power, here is the magnetic separator roll a pole into the material end, Jane go up by continue to slide down, until the nail surface, vertical in simplified location at this time is the material into the end of a pole in the heart.
5. Turn the connection on the large shaft turn buckle, make the material end core wire in a magnetic pole position, weir than concentrate (into the scraper is expected to end at the bottom of the stainless steel weir, concentrate from flow into qualified medium barrels)
6 rotation to the right place, with a nut tighten bolts flower basket, superior concentrate discharge scraper, fastening nut on both ends of the shaft, the magnetic declination adjustment is complete.Email:tompu8@gmail.com
So you need to adjust the magnetic separator magnetic declination, can operate according to the above steps, but must pay attention to the different types of magnetic separation equipment, the applicable adjustment way will also vary, so everyone must see in the previous steps.
Is a major production of iron remover, magnetic separator, eddy current separator, weighing feeder, batching scales, electronic belt scale manufacturer, welcome to call the advisory contact!Email:tompu8@gmail.com